Filter
Top Products
TO F~LAY A DVD OR LD RECORDED IN
DOLIBY DIGITAL SURROUND
This receiver is equipped with the Dolby Digital decoder and
has the DIGITAL IN (both OPTICAL and COAXIAL) terminals.
When a DVD or LD player isconnected to the DIGITAL INterminal
of the receiver, you can enjoy theater-quality audio right in your
home when playing discs recorded in Dolby Digital Surround.
Before operation
Check that the TAPE MONITOR is not selected. If the TAPE
MONITOR is selected, press the TAPE MONITOR button so that
“TAPE OFF appears on the display,
1
2
Turn the FUNCTION to select the VIDEO 1 (VIDEO
2 or VIDEO 3) and press the DIGITAUANALOG/
BAIND button repeatedly until “DIGITAL” is
displayed.
The DVD (LD) player connected to the OPTICAL (COAXIAL)
DIGIITALIN terminal is selected as a source.
Start playing the DVD (LD) recorded in Dolby
Digital Surround.
The ‘[DOLBY DIGITAL” indicator will light on the display when
the bit stream of the Dolby Digital Surround comes in the
unit.
To select the Dolby Digital Surround mode according to your
speakers, see “SELECTING DOLBY SURROUND” on page
15.
mim
* While the TAPE MONITOR isselected and the TAPE MONITOR
indicator turns red, “DIGITAL cannot be selected.
● When headphones are plugged in, the Dolby Digital Surround
mode is automatically changed to “2chSTERE0 and the “2CH
DOWNMIX indicator lights on the display.
Even if the DOLBY SURROUND button is pressed while the
headphones are plugged in, the mode cannot be changed.
● This unit supports input signals of the Dolby Digital Surround
bit stream and linear PCM whose sampling frequency is 32
kHz, 44.1 kHzand 48 kHz. The unit cannot play the DVDSwhose
sampling frequency is 96 kHz.
● When connecting some DVD player to the receiver through the
DIGITAL INterminals, noise maybe heard in the DVD operation:
e.g. searching a disc, skipping a chapter.
RECORDING Ahl AUDIO SOURCE
1
2
3
1 ENTER
TAPEMONITOR MULTIJOG
Select the program source to be recorded.
Turn the FUNCTION.
Set the tape deck or MD recorder to the recording
mode.
Start the selected program source.
To monitor recorded sound during recording (where the
connected tape deck is a three-head system)
Press the TAPE MONITOR button. “TAPE ON” appears (onthe
display for four seconds, and then the source name selected in
step 1comes back on. To cancel the tape monitor, press itagain
so that “TAPE OFF” appears.
m%f
●
✎
●
●
Any sound control system has no effect on recording (see
page 8).
Input sound through the DIGITAL IN terminals cannot be
recorded. When recording the sound from the DVD, CID,Ml)
or LD player, connect the analog AUDIO OUT terminals of
the player to the corresponding AUDIO IN terminals of the
receiver.
The sound will be recorded in 2 ch stereo.
When recording audio sources by the MD recorder connected
to the VIDEO 1/DVD/MD AUDIO OUT terminals, the selected
video source (see page 11) should be V2 or V:3. Recording
cannot be done while the VI (VIDEO 1) is selected and
displayed on the window,
Input sound from the tape deck connected to the TAPIE
MONITOR IN terminals cannot be recorded.