Filter
Top Products
CONNECTIONS
CONNECTING EQUIPMENT
Jacks and plugs of the connecting cord are color-coded as
follows:
Before connecting the AC cord
Red jacks and plugs: For the right channel of audio signals
The rated voltage of your unit shown on the rear panel is 120 V
White jacks and plugs: For the left channel of audio signals
AC. Check that the rated voltage matches your local voltage.
Yellow jacks and plugs: For video signals
IMPORTANT
m
Connect the .smeakers, antennas, and all other external
Insert the plugs fully into the jacks. Loose connections may
equipment first. then connect the AC cord at the end.
produce a humming sound or other noise interference.
*’ Be sure to connect the VIDEO OUT terminal of a DVD player
directly to aTV set, notthrough this unit. Otherwise, the picture
-
noise may appear when playing copy protected DVDS.
*2Input sound through the DIGITAL IN terminals cannot be
Q ‘.. ””...
o
.’ Q
recorded. When recording the sound from the DVD, CD, MD
Q). D
@
000 nn o ~ooo
or LD player, connect the analog AUDIO OUTterminals ofthe
f3m00
.0
playerto the correspondingAUDIO INterminals of the receiver.
*3When connecting a monaural video, use a stereo-mono
connecting cord (not supplied).
VIDEO3
‘4 When connecting an LD player equipped with the AC-3 RF
OUT terminal, use an RFdemodulator unit. Also connect the
analog AUDIO OUT terminals of the LD player to the receiver
to olav all the sources. For further information. refer to the -’T
,.
instructions of the LD player.
DVD or Video 1*3/MD player
MJJ4&#
to AUDIO OUT
)
Tv
o OPTICAL
31GITAL OUT
:DVD)
— Optical
connecting
cord
I I [ to AUDIO lNO/ideo I/MD) -
l{
to VIDEO lN(Video 1) A
[ to AUDIO OUT A
to VIDEO OUT(Video 1)*1 -
I
O@ical 4
I
connecting
to OPTICAL
cord
DIGITAL OUT
EiEa!Ez
DVD or MD,CD Player
I
to COAXIAL
DIGITAL OUT
RF demodulator*4
,..
@j
IN
w
k
Turntable
\
o LINE OUT
-k’{
m
3 ENGLISH
n
4
to LINE IN
Tape deck
#_
to AUI
Emm
—
J
i!
CD player
>
.==
to OUTPUT