Filter
Top Products
81
Operations using the remote
To change the button
assignments
You can change the factory settings of the
function buttons to suit the components in your
system. For example, if you connect a LD
player to the VIDEO 2 jacks on the receiver,
you can set the VIDEO2 button on this remote
to control the LD player.
Note, however, that the settings of the TUNER
button cannot be changed.
1 Press USE MODE for more than 2
seconds.
The indicator remains lit.
2 Press the function button you want to
change the assignment of.
The indicator turns off when a valid button
is pressed. Only the first function button
that is pressed will be registered.
Example: Press VIDEO2.
3 Press the function button for which you
want to change the assignment to.
See the table below for the factory assigned
categories of each button. To select “2nd
pressed” or “3rd pressed” categories, press
the same button twice or three times. The
indicator turns off when a valid button is
pressed.
Example: Press DVD/LD twice.
4 Press SOURCE.
The new assignment is registered.
The indicator slowly lights up twice, then
goes off.
Tip
If the operation is unsuccessful, the indicator flashes
twice and the remote automatically exits the button
assignment mode. In this case, the new assignment is
not registered and the previous setting remains.
Notes
• If you do not press a button during step 2 through 4
within thirty seconds, the remote automatically exits
the button assignment mode. Start again from step
1.
• In step 3, if you press the same button more than the
possible number of categories that can be selected,
only the last category is registered for the new
assignment.
• In step 3, if you press several function buttons, the
category of the last pressed button is selected.
Valid buttons and the corresponding
categories
Categories*
Button 1st pressed 2nd pressed 3rd pressed
VIDEO1 VTR1 VTR4 —
VIDEO2 VTR2 VTR5 —
VIDEO3 VTR3 VTR6 —
DVD/LD DVD player LD player —
TV/SAT TV SAT —
TAPE Tape deck A Tape deck B —
MD/DAT MD deck DAT deck —
CD/SACDCD player 1 CD player 2 CD player 3
* To assign to VIDEO CD, press VIDEO 1 first, then
press CD/SACD.