Filter
Top Products
83
Troubleshooting
Appendix
During playback
a) Displayed only when DISPLAY CONTROL >ALARM is set to “ON” or
“LIMITED”.
During thumbnail search, scene selection, and clip list operations
Alarm message in time data
display section
Alarm message in monitor video
section
Description/action
525/60 Disc
a)
DISC CANNOT BE PLAYED BACK.
USE DISC WITH HD 50I or HD 25P
RECORDING.
This appears when the system frequency of this
unit does not match that of the loaded disc.
Insert a disc that matches the system frequency,
or change this unit's system frequency setting
(see page 22).
DISC CANNOT BE PLAYED BACK.
USE DISC WITH DVCAM 625/50
RECORDING.
625/50 Disc
a)
DISC CANNOT BE PLAYED BACK.
USE DISC WITH HD 60I or HD 30P
RECORDING.
DISC CANNOT BE PLAYED BACK.
USE DISC WITH DVCAM 525/60
RECORDING.
HD 60I/30P
a)
DISC CANNOT BE PLAYED BACK.
USE DISC WITH HD 50I or HD 25P
RECORDING.
DISC CANNOT BE PLAYED BACK.
USE DISC WITH DVCAM 625/50
RECORDING.
HD 50I/25P!
a)
DISC CANNOT BE PLAYED
BACK.USE DISC WITH HD 60I or HD
30P RECORDING.
DISC CANNOT BE PLAYED
BACK.USE DISC WITH DVCAM 525/
60 RECORDING.
HD 23P Disc
a)
DISC CANNOT BE PLAYED BACK.
USE DISC WITH HD 60I or HD 30P
RECORDING.
DISC CANNOT BE PLAYED
BACK.USE DISC WITH HD 50I or HD
25P RECORDING.
DISC CANNOT BE PLAYED
BACK.USE DISC WITH DVCAM 525/
60 RECORDING.
DISC CANNOT BE PLAYED
BACK.USE DISC WITH DVCAM 625/
50 RECORDING.
Disc Error! DISC ERROR DETECTED. Use another disc.
Alarm message in monitor
video section
Description/action
CANNOT EXPAND CLIP
ANY FURTHER.
The clip cannot be expanded into more blocks.
This appears when the EXPAND button is pressed when the number of block is maximum, or
when the duration of an expanded thumbnail is 1 frame.
SELECTED ESSENCE
MARK
DOES NOT EXIST.
The selected essence mark does not exist.
This appears in the essence mark selection screen when the specified essence mark does not
exist on the disc.
SUB CLIP IS INVALID.
SET APPROPRIATE
IN/OUT POINTS.
The temporal relationship between the specified In and Out points in a TRIM operation (see
page 58) is not correct.
Reset so that the value of the Out point timecode is larger than the value of the In point
timecode.