Filter
Top Products
71
System Menu
Chapter 6 Menus
Setup Menu Operations
This section explains how to change menu settings.
Buttons used to change settings
Use the following buttons to change menu settings.
Changing the settings of basic items
The factory default setting is to display only the basic
items. To change the settings of basic items, proceed as
follows.
1
Press the M/MARK1 or m/MARK2 button to select
the required item.
REMOTE I/F [> Remote I/F]: Select how to perform remote
control, when the remote control switch is set to
REMOTE.
i.LINK [>> i.LINK]: Use the S400 connector.
*9PIN/RS-232C [>> 9P/232C]: Use either the REMOTE(9P)
connector or the RS232C connector, depending on the
setting of the remote connector selector switch.
9PIN(PARA)[>> Para Run]: Use the REMOTE(9P) connector
to connect several PDW-70MD units and perform remote
control from one of them specified as the parent.
BAUDRATE [> BaudRate]: Select the communications speed
(bps) of the RS232C connector.
*9600 [>> 9600]
19200 [>> 19200]
38400 [>> 38400]
57600 [>> 57600]
115200 [>> 115200]
i.LINK MODE [> i.LinkMode]: Select the type of connection
for the S400 connector.
*AV/C [>> AV/C]: AV/C connection.
FAM(PC REMOTE) [>> FAM]: FAM connection.
METADATA [Metadata]: Metadata settings Description
INDEX POSITION [> Index Pos]: Specify which frame to use
as the thumbnail image (index picture) when recording.
0SEC [>> 0 sec] to 10SEC [>> 10 sec]: The frame at 0
seconds to 10 seconds from the top of the clip, specified in
units of 1 second.
Factory default setting: *0SEC
STORE OWNER [> Ownership]: Create UMID owner
information.
The STORED OWNERSHIP screen appears.
For details, see Appendix “Setting UMID ownership
information” on page 90.
MENU GRADE [Menu grade]: Selection of menu items to
be displayed
Description
Determine whether to display basic items only or both basic
and enhanced items on the monitor screen and in the time
data display section when using the setup menu.
*BASIC [>> Basic]: Display basic items only.
ENHANCED [>> Enhanced]: Display both basic and
enhanced items.
INTERFACE SELECT [Interface]: Settings related to
interfaces
Description
Menu control buttons Functions
MENU button • Display and hide the menu.
• Return to the menu from
setting screens.
M/MARK1 and m/MARK2
buttons
These buttons move the
highlighted cursor up and down
within the current level to select
an item or setting. Hold down
one of these buttons to make
the highlighted cursor move
continuously.
</IN and ,/OUT buttons Press the ,/OUT button to go
down one level.
Press the </IN button to go
up one level.
Hold down one of these
buttons to make the highlighted
cursor move continuously.
RESET button • Returns the setting to the
factory default setting.
• Answer “No” to the question.
SET button • Saves the new setting in
memory.
• Answer “Yes” to the question.
Menu control buttons Functions