Filter
Top Products
23
MZ-R900
34. Adjust with the [VOL+] key (adjusted value up) or [VOL--]
key (adjusted value down) so that the adjusted value becomes
20.
35. Press the X key.
(0D65 is blinking)
36. Press the [DISPLAY] key on the remote commander for sev-
eral seconds (about 3 seconds) to exit the patch data write mode
(to return to the manual mode display in the test mode).
37. Press the X key to write the modified data. (The adjusted value
changes to CC)
38. The modified data writing is over, if the adjusted value changes
to DD.
39. Turn the power off.
20. Press the [VOL+] key once to change the blinking portion to
0D60.
21. Press the x key.
(00 is blinking)
22. Adjust with the [VOL+] key (adjusted value up) or [VOL--]
key (adjusted value down) so that the adjusted value becomes
08.
23. Press the X key.
(0D60 is blinking)
24. Press the [VOL+] key once to change the blinking portion to
0D61.
25. Press the x key.
(00 is blinking)
26. Adjust with the [VOL+] key (adjusted value up) or [VOL--]
key (adjusted value down) so that the adjusted value becomes
A1.
27. Press the
X key.
(0D61 is blinking)
28. Press the [VOL+] key once to change the blinking portion to
0D62.
29. Press the x key.
(00 is blinking)
30. Adjust with the [VOL+] key (adjusted value up) or [VOL--]
key (adjusted value down) so that the adjusted value becomes
04.
31. Press the X key.
(0D62 is blinking)
32. Press the [VOL+] key once to change the blinking portion to
0D65.
33. Press the x key.
(00 is blinking)
023 0D6000
Remote commander LCD display
00
:Adjusted value
023 0D6008
Remote commander LCD display
08
:Adjusted value
023 0D6100
Remote commander LCD display
00
:Adjusted value
023 0D61A1
Remote commander LCD display
A1
:Adjusted value
023 0D6200
Remote commander LCD display
00
:Adjusted value
023 0D6204
Remote commander LCD display
04
:Adjusted value
023 0D6500
Remote commander LCD display
00
:Adjusted value
023 0D6520
Remote commander LCD display
20
:Adjusted value
023 Patch01
Remote commander LCD display
01
:Adjusted value
023 ***SDD
Remote commander LCD display
DD
:Adjusted value
• Modified Data Writing Method (version 1.100)
1. Select the manual mode of the test mode, and set item number
022 (see page 13).
2. Press the X key to initialize the patch data.
(The modified data writing is over, if the adjusted value changes
to DD)
3. Press the N key or > key to set item number 023.
4. Press the [VOL+] key once to change the adjusted value to 01.
5. Press the [DISPLAY] key on the remote commander for sev-
eral seconds (about 3 seconds) to activate the patch data write
mode.
(The following display will appear where 00 is blinking)
6. Press the X key.
(0D5C is blinking)
7. Press the [VOL+] key once to change the blinking portion to
0D5D.
023 0D5C00
Remote commander LCD display
00
:Adjusted value
023 0D5D00
Remote commander LCD display
00
:Adjusted value
023 Patch00
Remote commander LCD display
00
:Adjusted value
022 PatClr CC
Remote commander LCD display
022 ***SDD
Remote commander LCD display
DD
:Adjusted value