Filter
Top Products
69
There is no R-
channel sound
output when
playing a track
recorded from a
cassette deck or
through an
amplifier, or when
listening to sound
from a cassette deck
or amplifier.
• There is no R-channel output if the cassette deck or an amplifier is
connected with a monaural cord.
, Make sure to use a stereo connecting cord. If, however, the
connected equipment is monaural, there will be no R-channel
sound output even with a stereo connecting cord.
While editing
Symptom Cause/Remedy
“NotENOUGH
POWER TO EDIT”
appears and editing
cannot be done on a
1GB Hi-MD disc.
• Editing is not possible when using a 1GB Hi-MD disc even when the
battery level indication shows enough power remaining while the
recorder is stopped or playing. This is because of a mechanism that
disables editing when the remaining battery power is estimated by the
recorder to be insufficient due to the high power consumption required
for 1GB Hi-MD disc editing.
, Insert a new alkaline dry battery or connect the AC power adaptor
(not supplied) to the recorder.
The lid does not
open.
• The power sources have been disconnected during recording or editing,
or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery with
new ones.
Editing cannot be
done.
• The power source has been disconnected or a power outage has
occurred during editing.
, The editing done to that point is not saved to the disc. Do the
editing operation again.
Non-audio data
cannot be erased.
• Non-audio data cannot be erased with the Erase function.
, Confirm the contents by connecting the recorder to your computer.
If it is okay to delete the contents, then perform the Format
function (page 50).
Symptom Cause/Remedy
continued