Sony MX750NI Stereo System User Manual


 
34
GB
To use the system as a battery
charger
You can use the system as a battery charger for the
iPod/iPhone when the system is on.
Charging begins when the iPod/iPhone is placed
on the iPod/iPhone connector. The charge status
appears on the iPod/iPhone display. For details,
see the operating manual supplied with your iPod/
iPhone.
To stop charging the iPod/iPhone
Remove the iPod/iPhone from the iPod/iPhone
Dock on the unit. Turning off the system also stops
charging the iPod/iPhone.
Notes
When placing or removing the iPod/iPhone, handle the
iPod/iPhone at the same angle as that of the iPod/
iPhone connector on the unit; to prevent connector
damage, do not twist or sway the iPod/iPhone.
Do not carry the unit with an iPod/iPhone set on the
connector. Doing so may cause a malfunction.
When placing or removing the iPod/iPhone, brace the
unit with one hand and take care not to press the
controls of the iPod/iPhone by mistake.
Before disconnecting the iPod/iPhone, pause playback.
Hold down ./> to search forward or backward
while playing a video if m/M does not function.
Because the operation of the system and the iPod/
iPhone are different, you may not operate the iPod/
iPhone using buttons on the remote or unit. In this case,
use control buttons on the iPod/iPhone.
When the iPhone is connected to the system and you
receive a call during playback, playback will pause and
you can take the incoming call.
To change the volume level, press VOLUME +/– on the
remote. The volume level will not change when
adjusted on the iPod/iPhone.
The iPod/iPhone Dock on the unit is designed for iPod/
iPhone only. You cannot connect any other portable
audio players.
To use an iPod/iPhone, refer to the operating manual
supplied with your iPod/iPhone.
Sony cannot accept responsibility in the event that data
recorded on the iPod/iPhone is lost or damaged when
using an iPod/iPhone with this unit.