Filter
Top Products
32
Timer recording radio
programmes (continued)
When you press ENTER/YES, the start time,
stop time and other setting contents appear in
turn, then the original display returns.
“REC” lights up.
Note
You cannot activate another MD deck (except
for the optional MD deck MDS-SP55) with this
system’s recording timer.
7 Insert a blank tape.
8 Press ?/1 to turn off the system.
To cancel the procedure
Press CLOCK/TIMER SET.
To change the setting
Start over from step 1.
To check the setting/activate
the timer
Press CLOCK/TIMER SELECT and press .
or > repeatedly until “SEL TAPE REC” (or
“SEL MD REC” when using the optional MD
deck MDS-SP55) appears. Then press ENTER/
YES.
It is not necessary to set the start and stop times
every time.
To cancel the timer
Press CLOCK/TIMER SELECT and press .
or > repeatedly until “TIMER OFF” appears.
Then press ENTER/YES.
4 Set the time to start recording.
Press . or > repeatedly to set the hour,
then press ENTER/YES.
The minute indication flashes.
Press . or > repeatedly to set the
minute, then press ENTER/YES.
The hour indication flashes again.
5 Set the time to stop recording following
the procedure in step 4.
“OFF TIME NG” appears if the start time
and the stop time settings are the same.
Change the stop time.
6 Press . or > repeatedly to select
the recording source, then press
ENTER/YES.
The indication changes as follows:
When recording on a tape
t TUNER c TAPE
r
AUX* c TAPE
When recording on an MD with the optional
MD deck MDS-SP55
t TUNER c MD
r
TUNER c MD (M)**
r
AUX c MD
r
AUX c MD (M)
* You can select the connected component for
recording source. Set the timer on both
systems to the same time.
** When you record onto an MD in monaural
format.