Sony 702P Stereo System User Manual


 
1-15
DFS-700/700P
Chapter 3 Basic Operation
3-2
Chapter 3 Basic Operation
Example Operation (1): Wipe
In this example we’ll use the AUTO TRANS button, to make a wipe, with
the new image appearing from the center of the screen.
Setting items
As an example, we’ll set the control panel as follows.
Background image (the image output before the transition): video
signal connected to the VIDEO INPUT 1 connector
Foreground image (the image output after the transition): video
signal connected to the VIDEO INPUT 2 connector
Effect: wipe (pattern number 24)
Transition time: 30 frames
Program output
Executing the above effect produces the following changes in the output
on a program monitor connected to the PGM OUT connector of the
processor unit.
DME Switcher Introduction
Start of effect
Transition time
End of effect
Chapter 3 Basic Operation
Chapter 3 Basic Operation
3-3
<Preparation>
<Image selection>
Procedure
1
Pull the fader lever toward you as far as it will go.
2
Press BACKGROUND Bus button 1.
The pressed button lights red, and the video signal connected to the
VIDEO INPUT 1 connector is selected as the background image. The
selected background image appears on the program monitor.
3
Press FOREGROUND Bus button 2.
The pressed button lights amber, and the video signal connected to the
VIDEO INPUT 2 connector is selected as the foreground image.
To check the selected image on the program monitor, move the fader
lever to the opposite end. After checking, return the lever to the
position closest to you.
If a preview monitor is connected, the selected foreground image
appears in the preview monitor.
4
Press the DIRECT PATTERN button, turning it on.
(If it is already lit, omit this step.)
The unit is now in direct pattern selection mode. In this mode, you can
select the eleven patterns assigned to buttons in the pattern/numeric
keypad using the corresponding button.
LAST X
INS
RST
TITLE
12
EDITOR LUM LUM LUM
DSK EDGE
TRAIL
SHADOW
GPI CRK CRK BORDERBEVELD
EDGE
SET UP MASK MASK MASK SOFT
SHIFT CCR LIGHTING BORDERMATTES
LOCATION
LEARNEDIT
RECALL
HOLD
INPUT
INITIAL
PATTERN
ADJ
PAGE
F1 F2 F3 F4 F5
USER PGM
STATUS EDIT
SNAP SHOT
SET
PATTERN NUMBER
EFFECT
DSK
FTB
SET
TRANS RATE
789
456
123
0
DOWN UP
ENTER
FADE
TO
BLACK
P IN P
DSK
DEL
N/R REV DSK PVWDIRECT
RECALL
DIRECT
PATTERN
CCR TITLE 1
SOURCE
TITLE 2
SOURCE
DSK
FILL
SUPER BGFRGD 2MEMORYFRAME FREEZ MIX EFFECT
BACKGROUND
BLACK MEMORY INT
VIDEO
TITLE
12345678
CUT
AUTO
TRANS
AUXILIARY
BLACK
MEMORY
INT
VIDEO
12345678
FOREGROUND
BLACK
MEMORY
INT
VIDEO
12345678
PATTERN/KEY PAD
8
910
3
2
1
6
5,7
4
(Continued)
<Effect selection>