Filter
Top Products
22
GB
3 Start transferring.
For CD-USB Synchronized
Transfer:
Press REC TO USB.
“SYNC” and “REC” light up in the
display. Then, transferring starts when
“Don’t Remove USB” appears in the
display.
When the transferring is completed,
the disc and the USB device stop
automatically.
For REC1 Transferring:
Press REC TO USB.
“REC” lights up in the display. Then,
transferring starts when “Don’t
Remove USB” appears in the display.
When the transferring is completed,
the disc continues to play.
For Manual Transferring:
Press REC TO USB.
“REC” lights up in the display. Then,
transferring starts when “Don’t
Remove USB” appears in the display.
Start playback the source to be
transferred.
A new file is automatically created
after approximately 1 hour of
transferring.
You can also create a new file any time
during transferring by pressing REC
TO USB. “New Track” appears in the
display and transferring continues as a
new file.
However, if you press REC TO USB
after a few seconds from the new file
creation, the file cannot be created and
“Not in Use” appears in the display.
To stop transferring, press x.
Tip
If noise is heard while transferring from the
radio, move the respective antenna to reduce
the noise.
Notes
• Transferring stops automatically when you
change the function or tuner band on
CHANNEL B.
• When a new MP3 file is created, a few
seconds of music source would be lost.
To select the transferring
destination on the USB device
If the USB device has more than one
memory (for example, internal memory
and a memory card), you can select which
memory to read to and then start
transferring.
1 Connect the USB device to the
(USB) port on the unit.
2 Press OPTIONS.
3 Turn JOG DIAL to select “USB
SELECT”.
4 Press ENTER.
The name of a memory is displayed.
The displayed name vary depending on
the specifications of the USB device.
5 Turn JOG DIAL to select the drive
you want.
If only one memory can be selected,
proceed to step 6.
To cancel this operation, press
OPTIONS.
6 Press ENTER, then press
OPTIONS to exit the OPTIONS
menu.
7 Start transferring by following steps
2 and 3 of “Transferring onto an
USB device” (page 21).