Filter
Top Products
47
GB
D:\NORM'S JOB\SONY HA\SO0054\STR-DA2400ES\CEL VERSION\3289204423\04GB-
STRDA2400ESUC\030CON_GB.fm
masterpage: Right
STR-DA2400ES
3-289-204-42(3)
Getting Started
To cancel the measurement
The measurement will be canceled when you
do the following:
–Press ?/1, input buttons or MUTING.
– Press SPEAKERS (OFF/A/B/A+B) on the
receiver.
– Change the volume level.
– Connect the headphones.
1 Confirm the measurement
result.
When the measurement ends, a beep
sounds.
2 Press V/v to select the item you
want, then press .
* When the speaker(s) is (are) out of the phase,
“OUT” is displayed on the TV screen. The
“+” and “–” terminals of the speaker may be
connected the other way around. However,
depending on the speakers, “OUT” appears
on the TV screen even though the speakers
are connected properly. This is because of the
speakers’ specifications. In this case, you can
continue to use the receiver.
3 Select “Save” in step 2, then
press to save the
measurement result.
Confirming/saving the
measurement results
Item Explanation
Retry Performs the Auto
Calibration again.
Save Saves the measurement
results and exits the setting
process.
Warning Displays warning
concerning the
measurement results. See
“Message list after Auto
Calibration measurement”
(page 49).
Phase* Displays the phase of each
speaker (in phase/out of
phase).
Distance Displays the measurement
result for speaker distance.
Level Displays the measurement
result for speaker level.
Exit Exits the setting process
without saving the
measurement results.
continued