Sony 3-289-204-42(3) Stereo Receiver User Manual


 
118
GB
D:\NORM'S JOB\SONY HA\SO0054\STR-DA2400ES\CEL VERSION\3289204423\04GB-
STRDA2400ESUC\110ADD_GB.fm
masterpage: Left
STR-DA2400ES
3-289-204-42(3)
Dolby Digital or DTS multi channel
sound is not reproduced.
Check that the DVD, etc. you are playing
is recorded in Dolby Digital or DTS
format.
When connecting the DVD player, etc., to
the digital input jacks of this receiver,
make sure the setting for the digital audio
output of the connected component is
available.
Recording cannot be carried out.
Check that the components are connected
correctly (page 19).
Select the source component using INPUT
SELECTOR (page 50).
The MULTI CHANNEL DECODING lamp
does not light up in blue.
Check that the playback component is
connected on a digital jack and the input is
selected properly on this receiver.
Check whether the input source of the
software being played back corresponds to
the multi channel format.
Check whether the setup on the playback
component is set to multi channel sound.
Check to make sure the selected audio
(digital) input jack is not assigned to other
inputs in “Input Assign” in the Input menu
(page 88).
There is no sound from the component
connected to the DIGITAL MEDIA PORT
adapter.
• Adjust the volume of this receiver.
• The DIGITAL MEDIA PORT adapter
and/or component is not connected
correctly. Turn off the receiver, then
reconnect the DIGITAL MEDIA PORT
adapter and/or component.
• Check the DIGITAL MEDIA PORT
adapter and/or component device to make
sure it supports this receiver.
Video
There is no picture or an unclear
picture appears on the TV screen or
monitor.
Select the appropriate input on the receiver
(page 50).
Set your TV to the appropriate input mode.
Move your TV away from the audio
components.
Assign the component video input
correctly.
The input signal should be same as the
input function when you are up-converting
an input signal with this receiver
(page 32).
Recording cannot be carried out.
Check that the components are connected
correctly (page 24).
Select the source component using INPUT
SELECTOR (page 50).
The GUI mode does not appear on the
TV screen.
Press GUI MODE repeatedly to select
“GUI ON”. If the GUI menu still does not
appear on the TV screen, press MENU.
Check the TV is connected correctly.