Filter
Top Products
119
GB
D:\NORM'S JOB\SONY HA\SO0054\STR-DA2400ES\CEL VERSION\3289204423\04GB-
STRDA2400ESUC\110ADD_GB.fm
masterpage: Right
STR-DA2400ES
3-289-204-42(3)
Additional Information
HDMI
The source sound input to the HDMI
jack is not output from the receiver or
the TV speaker.
• Check the setting of “Audio Out” in the
HDMI settings menu (page 57).
• Check that the component is connected
correctly to the HDMI jack for that
component.
• You cannot listen to the Super Audio CD
by connecting HDMI.
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
• Be sure to use a connecting cable for the
HDMI jack corresponding to high speed
(an HDMI version 1.3a, category 2 cable)
when you view images or listen to sound
during a Deep Colour (Deep Color)
transmission.
The source image input to the HDMI
jack is not output from the TV.
• Check the HDMI connection (page 26).
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with the each component.
• Be sure to use a connecting cable for the
HDMI jack corresponding to high speed
(an HDMI version 1.3a, category 2 cable)
when you view images or listen to sound
during a Deep Colour (Deep Color)
transmission.
The Control for HDMI function does not
work.
• Check the HDMI connection (page 26).
• Make sure “Control for HDMI” is set to
“ON” in the HDMI menu.
• Make sure the connected component is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected component. Refer to the
operating instructions of the connected
component.
• If you change the HDMI connection,
connect/disconnect the AC power cord, or
there is a power failure, repeat the
procedures of “Preparing Control for
HDMI function” (page 79).
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
• If the TV does not have System Audio
Control function, set the “Audio Out”
settings in HDMI menu to
–“TV+AMP” if you want to listen to the
sound from the TV speaker and receiver.
–“AMP” if you want to listen to the sound
from the receiver.
• If you cannot listen to the sound of a
component connected to the receiver
–Change the input of the receiver to
HDMI when you want to watch a
program on a component connected via
HDMI connection to the receiver.
–Change the TV channel when you want
to watch a TV broadcast.
–Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
continued