Filter
Top Products
10
GB
D:\NORM'S JOB\SONY HA\SO0054\STR-DA2400ES\CEL VERSION\3289204423\04GB-
STRDA2400ESUC\030CON_GB.fm
masterpage: Left
STR-DA2400ES
3-289-204-42(3)
Name Function
A AV ?/1
(on/standby)
Press to turn on or off the audio/
video components that the
remote is programmed to
operate.
To turn the TV on or off, press
TV (X) and then press AV
?/1.
If you press ?/1 (B) at the
same time, it will turn off the
receiver and other Sony
components (SYSTEM
STANDBY).
Note
The function of the AV ?/1
switch changes automatically
each time you press the input
buttons (D).
B ?/1
(on/standby)
Press to turn the receiver on or
set it to standby mode.
To turn off all Sony
components, press ?/1 and AV
?/1 (A) at the same time
(SYSTEM STANDBY).
Saving the power in standby
mode.
When “Control for HDMI”
(page 79) is set to “OFF”.
C AMP Press to enable the receiver
operation (page 96).
D Input
buttons
Press one of the buttons to
select the component you want
to use. When you press any of
the input buttons, the receiver
turns on. The buttons are
factory assigned to control Sony
components (page 50). You can
program the remote to control
non-Sony components
following the steps in
“Programming the remote” on
page 107.
Numeric
buttons
(number 5
a)
)
Press SHIFT (W) and then
press numeric buttons to
– preset/tune to preset stations.
– select track numbers of the
CD player, VCD player, LD
player, DVD player, MD
deck, DAT deck, or tape
deck. Press 0/10 to select
track number 10.
– select channel numbers of
the VCR, satellite tuner, Blu-
ray disc player, PSX, DVD/
VHS COMBO, or DVD/
HDD COMBO.
Press TV (X), and then press
the numeric buttons to select the
TV channels.
ENT/MEM Press SHIFT (W) and then
press ENT/MEM to
– enter the value after selecting
a channel, disc or track using
the numeric buttons of the
VCR, CD player, VCD
player, LD player, MD deck,
DAT deck, tape deck,
satellite tuner, Blu-ray disc
player, or PSX.
– store a station during tuner
operation.
To enter the value of Sony TV,
press TV (X) and then press
ENT/MEM.
CLEAR Press SHIFT (W) and then
press CLEAR to
– clear a mistake when you
press the incorrect numeric
button of the DVD player,
Blu-ray disc player, PSX,
satellite tuner, DVD/VHS
COMBO, or DVD/HDD
COMBO.
– return to continuous
playback, etc. of the satellite
tuner or DVD player.
-/-- Press SHIFT (W) and then
press -/-- to select the channel
entry mode, either one or two
digit of the VCR or satellite
tuner.
To select the channel entry
mode of the TV, press TV (X)
and then press -/--.
Name Function