Filter
Top Products
56
System Normal Commands
These commands return the control system to a known, safe state. Some normal
commands reset parts of the control system and other commands can reset all control
system states to a known condition.
C300 (u) Site normal
Sets normal conditions for the entire control system including all groups.
• Sets CTCSS / DCS required to on,
• Sets link delay on
• Connects or disconnects (link on/off) ports according to their
normal link state as defined in the group definitions (all on in the
default configuration)
• Turns on audio loopback on repeater ports only
• Turns off audio loopback on all other port types
• Turns remote monitor modes off
• Disables remote base transmitters
• Executes remote normal (C303) command.
C301 (u) Link normal
Operates on the current group only.
• Connects link, VOIP/IRLP, and remote base ports according to their
normal
• Link state as defined in the group definitions
• Disconnects (unlinks) all local radios.
• Disables remote base transmitters (use C380 to enable).
C302 (u) Interface normal
Operates on the current group only
• Connects all ports which are defined as normally linked in the group
definitions
• Not connected for VOIP and remote base ports.
• Disables the remote base transmitters (enable with C380).
• This can be used to reconnect the repeaters after a link normal (C301)
command.
C303 (u) Remote normal
• Clears unlocked conditions
• Turns off the force transmitter on test condition
• Turns off the test tones
• An unlock code will need to be reentered before executing subsequent