Filter
Top Products
58
Continued
■When selecting the HD Audio
• When the source components that cannot support the HD audio signal format (such as Dolby Digital Plus, Dolby TrueHD,
DTS-HD High Resolution Audio, DTS-HD Master Audio, etc.) are connected to the HDMI IN of this receiver, some
components may not output any audio signals from its HDMI OUT.
In this case, you should set the HD Audio to Off to play the audio signals other than the HD audio signals. (For details on the
audio signal format, refer to the operating instructions of the source component.)
On : To play the audio signals (including the HD audio signals).
↕
Off : To play the audio signals other than the HD audio signals.
ENGLISH
When selecting the Re-Name
1. Press the CURSOR UP/DOWN buttons to select the desired input source, then press the CURSOR RIGHT
button to enter the setting menu.
• You can give names to the input sources other than tuner.
• Up to 8 characters can be entered for each name.
Example : When selecting the VIDEO 1 as an input source
2. Press the CURSOR UP/DOWN buttons to select the Re-Name, then press the CURSOR RIGHT button to
enter the setting menu.
Cancel VIDEO 1 Finish
■To resume its factory input source name
• Enter a blank on each digit.
• Then the cursor moves to the desired digit.
• You can enter the desired among blank, A~Z, a~z, 0~9, (, ),
+, ,, ― , ., /.
3. Press the CURSOR LEFT/RIGHT buttons to select the desired digit.
4. Press the CURSOR UP/DOWN buttons to enter the desired character on the selected digit.
5. Repeat the above steps 3 and 4 to enter the desired characters on the rest of the digits.
RD-8504(A)_ENG_091118:RD-8504(A)2009-11-18오 6:41페이지58