Filter
Top Products
ENGLISH
27
Adjusting the current channel level
• Each time these buttons are pressed, the corresponding
channel is selected as follows:
→CAL (or MOVIE, etc.) ↔FL ←C ←FR ←SR ←
→<LFE> ↔SUB ↔SL(↔SB) or (↔SBL ↔SBR) ←
DTS LFE or Dolby Digital LFE
( ): Possible depending on whether the surround back channel is
set to "2 Channel" or "1 Channel (Left)".
< >: Possible only when the digital signals from Dolby Digital, DTS,
Dolby TrueHD or DTS HD program sources that include LFE
signal are input.
• Depending on the speaker settings("No", etc.) and
surround mode, etc., some channels cannot be selected.
• When the SPEAKER button is set to off, only the Front
Left, Front Right(and LFE) channels can be selected.
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory
("CAL"), not into preset memory("MOVIE" for movie source, "MUSIC" for music source).
• The LFE level can be adjusted within the range of -10 ~
0 dB and other channel levels within the range of -15 ~
+15 dB.
• In general, we recommend the LFE level to be adjusted
to 0 dB.(However, the recommended LFE level for some
early DTS software is -10 dB.) If the recommended
levels seem too high, lower the setting as necessary.
• Then the memory mode ("CAL", "MOVIE", etc) is displayed
for several seconds.
• When the memory mode or channel level disappears,
press this button again.
1. Press the CHANNEL LEVEL button.
3. Adjust the level of the selected channel as desired.
4. Repeat the above steps 2 and 3 to adjust each channel level.
2. Select the desired channel.
RD-8504(A)_ENG_091118:RD-8504(A)2009-11-18오 6:41페이지27