Filter
Top Products
53
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory
("Calibrate"), not into preset memory("Save 1(Movie)", "Save 2(Music)").
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes.(For details, refer to "Adjusting each channel level with test tone" on page 26.)
• The LFE level can be adjusted within the range of -10 ~ 0 dB and other channel levels within the range of -15 ~ +15 dB
• In general, we recommend the LFE level to be adjusted to 0 dB.(However, the recommended LFE level for some early DTS
software is -10 dB.) If the recommended levels seem too high, lower setting as necessary.
• When the CURSOR LEFT button is pressed on the setting menu, the previous menu will be returned to.
When selecting the Channel Level
1. Press the CURSOR UP/DOWN buttons to select the Channel Level, then press the CURSOR RIGHT button
to enter the setting menu.
4. Repeat the above steps 2 and 3 to adjust each channel level.
3. Press the CURSOR UP/DOWN buttons to adjust the level of the selected channel or program source’s LFE
as desired.
■When selecting the LFE
• Press the CURSOR UP/DOWN buttons to select the desired program source’s LFE, then press the CURSOR RIGHT
button to enter its setting menu.
■Note :
• Depending on the speaker settings(“No”, etc.), some channels cannot be selected.
2. Press the CURSOR UP/DOWN buttons to select the desired channel(, not “MODE”), then press the
CURSOR RIGHT button to enter its setting menu.
ENGLISH
MODE
Front Left
Center
Front Right
Surround Right
Surr Back Right
Surr Back Left
Surround Left
Subwoofer
LFE
BACK NEXT
RD-8504(A)_ENG_091118:RD-8504(A)2009-11-18오 6:41페이지53