Filter
Top Products
ENGLISH
47
SETTING THE SPEAKER / ROOM EQ SETUP
• After you have installed this receiver and connected all the components, you should adjust the speaker settings for the
optimum sound acoustics according to your environment and speaker layout.
• Even when you change speakers, speaker positions, or the layout of your listening environment, you should adjust the
speaker settings, too.
• When performing the Auto Setup procedure, you need not perform the Speaker Configuration, Speaker Crossover, Speaker
Distance and Channel Level setup procedures.
• Auto Setup : To set the speaker setup and channel level setup
automatically.
• Room EQ : To select the desired room EQ mode.
• Speaker Configuration : To adjust the speakers depending on
whether they are connected or not.
• Speaker Crossover : To select the desired crossover frequency.
• Speaker Distance : To select the distance between the listening
position and each speaker to set the delay
time automatically for optimum surround
playback.
• Channel Level : To adjust the channel levels as desired or to
memorize them into the preset memory.
When selecting the Auto Setup
• Auto Setup lets you avoid troublesome listening-based speaker setup and achieve good surround sound. Auto Setup has the
feature that provides the optimum listening environment at the listening position in your room.
You should connect the supplied microphone to the SETUP MIC jack so that this receiver can analyze the information from a
series of test tones emitted from speakers at main listening position and can adjust the configuration, distance, sound level,
crossover frequency and frequency response of each speaker automatically.
• If you want to personalize your speaker setup and channel level setup by making the settings manually, perform the "When
selecting the Speaker Configuration" on page 50, "When selecting the Speaker Crossover" on page 51, "When selecting the
Speaker Distance" on page 52 and "When Selecting the Channel Level" on page 53.
• After the auto setup has been completed, set the room EQ as desired. (For details, refer to "When selecting the Room EQ" on
page 49.)
■Preparations
①. Check that the speakers are securely connected to this receiver.
• If your subwoofer has adjustable volume and crossover frequency, set the volume halfway and set the crossover
frequency to the maximum or the low pass filter off.
②. Connect the supplied microphone to the SETUP MIC jack on the front panel.(For details, refer to "SETUP MIC JACK" on
page 14.)
■Notes :
• Because the microphone for Auto Setup is designed for use with this receiver, to use the auto setup function, do not use a
microphone other than the one supplied with this receiver.
• After you have completed the auto setup procedure, disconnect the microphone.
• If possible, use a tripod, etc. to attach the microphone at the same height as your ears would be when you are seated in your
listening position.
• Ensure there are no obstacles between the speakers and the microphone.
1. Place the microphone on a flat level surface at the listening position.
Auto Setup
Room EQ
Speaker Config
Speaker X-over
Speaker Distance
Channel Level
BACK NEXT
RD-8504(A)_ENG_091118:RD-8504(A)2009-11-18오 6:41페이지47