Filter
Top Products
46
SELECTING THE SURROUND MODE
Example) When digital signals from Dolby Digital EX 6.1 channel source are input.
Notes :
• Depending on the input signal format, surround back speaker setting
and the selected decoding mode, the selectable surround modes may
differ.
• When the EXTERNAL IN is selected as input source, the
SURROUND MODE cannot be selected.
• Press the CURSOR UP( )/DOWN( ) buttons to select the desired surround mode.
• In case of playing analog stereo, PCM 2
channel or Dolby Digital 2 channel source in a
Dolby Headphone mode, press the CURSOR
LEFT( )/ RIGHT( ) buttons to select the
desired listening mode.
Set the selected mode as desired.
3
When the TONE CONTROL mode is selected, press
the ENTER button to select the desired mode.
• Each time this button is pressed, the mode
changes as follows:
ON: When adjusting the tone for your taste.
(“DIRECT” indicator goes off.)
OFF: When listening to a program source without the
tone effect.(“DIRECT”indicator lights up.)
When the BASS or TREBLE mode is selected, press
the CURSOR LEFT( )/RIGHT( ) buttons to adjust
the tone as desired.
• The tone level can be adjusted within the range
of -10 ~+10 dB
• In general, we recommend the bass and treble
to be adjusted to 0 dB(flat level)
• Extreme settings at high volume may damage
your speakers.
• To complete tone adjustment, repeat the above
steps and .