Filter
Top Products
29
ENJOYING SURROUND SOUND
Depending on the input digital signal format, select the desired decoding mode.
1
• Each time the AUTO button is pressed, the decoding mode
changes as follows :
Select the desired surround mode.
2
• Each time the DSP MODE (<) or (>) button is pressed,
the surround mode changes depending on the input signal
format and the selected decoding mode as follows :
Signal format being input Selected decoding mode Selectable surround mode
Dolby Digital EX 6.1 channel sources IN-AUTO mode DOLBY DIGITAL EX, DOLBY D VS REF, DOLBY D VS WIDE
Dolby Digital 5.1 channel sources <DOLBY D PLIIx MUSIC>, DOLBY DIGITAL, DOLBY D VS REF, DOLBY D VS WIDE
Dolby Digital 2 channel sources <DOLBY D PLIIx MOVIE, DOLBY D PLIIx MUSIC,> / [DOLBY D PLII MOIVE,
DOLBY D PLII MUSIC,] DOLBY PRO LOGIC, DOLBY D VS REF, DOLBY D VS
WIDE
DTS sources IN-AUTO, IN-DTS mode (DTS +NEO: 6,) corresponding DTS mode, DOLBY VS REF, DOLBY VS WIDE
MPEG sources IN-AUTO mode MPEG
96 kHz PCM(2 channel) sources IN-AUTO, IN-PCM mode DOLBY PLII MOVIE, DOLBY PLII MUSIC, DOLBY PRO LOGIC, DOLBY VS
REF, DOLBY VS WIDE
PCM( 2 channel ) sources <DOLBY PLIIx MOVIE, DOLBY PLIIx MUSIC,> / [DOLBY PLII MOVIE, DOLBY
Analog stereo sources
-
PLII MUSIC,] DOLBY PRO LOGIC, DOLBY VS REF, DOLBY VS WIDE, NEO: 6
CINEMA, NEO: 6 MUSIC, THEATER, HALL, STADIUM
• Depending on surround back speaker setting, some surround modes can be selected or not as follows:
< >: Possible only when surround back speaker is not set to “None”.
[ ] : Possible only when surround back speaker is set to “None”.
( ): Possible only when surround back speaker is not set to “None” while playing the digital signals from DTS sources except DTS ES 6.1 channel sources.
Notes:
• When the selected decoding mode is not matched to the input signal format, the “DIGITAL” indicator
flickers and no sound is heard. Therefore, be sure to select the required decoding mode and the available
surround mode according to the input signal format.
• When the EXTERNAL IN is selected as an input source, the decoding and surround modes cannot be
selected.
• When the digital signals are not inputted, the desired surround mode cannot be selected.
Notes :
• Only when the digital input is selected as signal input for the input sources except TUNER, TAPE, AUX
and EXTERNAL IN, the decoding mode can be selected.
• Noise may be generated at the beginning of playback and while searching during DTS playback in the IN-
AUTO mode. In this case, try playing in the IN-DTS mode.
Note:
• Before surround playback, first perform the SPEAKER SETUP procedure, etc. for optimum performance. (For details, refer to
“Speaker Setup” on page 18.)