Filter
Top Products
35
Repeat the above steps to to
memorize other stations.
4
After selecting the tuner as an input
source, select the preset tuning mode.
1
Listening to FM stereo broadcasts
• The station has now been stored in the memory.
• A stored frequency is erased from the memory
by storing another frequency in its place.
• If “MEM” goes off, start again from the above
step .
• Then “PRESET” lights up.
MEMORY BACKUP FUNCTION
The following items, set before the receiver is
turned off, are memorized.
• INPUT SELECTOR settings
• Surround mode settings
• Preset stations,etc.
• While listening to FM broadcasts.
• Each time this button is pressed, the FM mode
changes as follows;
Scanning preset stations in sequence
• The receiver will start scanning the stations in the
preset sequence and each station is received for 5
seconds.
• At the desired station, press this button again to
stop scanning.
• When pressing the PRESET +/- buttons on the
remote control, you need not select the preset
tuning mode on step .
Tuning to preset stations
Select the desired preset number.
2
Select the desired preset number
(1~30) and press the MEMORY/ENTER
button.
3
• When FM stereo broadcasts are poor because
of weak broadcast signals, select the FM mono
mode to reduce the noise, then FM broadcasts
are reproduced in monaural sound.