Filter
Top Products
32
At each channel, adjust the level as
desired until the sound level of each
speaker is heard to be equally loud.
2
Cancel the test tone function.
3
• You can select the desired channel and adjust its
level with repeating the steps and in
“Adjusting the current channel level” procedure.
Adjusting the current channel level
Press the CHANNEL SELECTOR button.
1
• Each time this button is pressed, “REF. 1” (or
“USER”) is displayed and the corresponding
channel is selected as follows:
< >: Possible only when the digital signals from Dolby Digital or DTS
program sources that include LFE signal are input.
• Depending on the speaker setting and surround mode, etc., some channels cannot be selected.
• When the SPEAKER button is set to off, only the front L/R channel can be selected.
• After adjusting each channel level with test tone, adjust the channel levels either according to the
program sources or to suit your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into
user’s memory(“USER”), not into preset memory(“REF. 1”, “REF. 2”).
Adjust the level of the selected channel as
desired.
2
• The LFE level can be adjusted within the range of
-10~0 dB and other channel levels within the range
of -15~+15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower the
setting as necessary.
• If the channel display disappears, start from the
step again.
Repeat the above steps and to adjust each channel level.
3