Filter
Top Products
22
Specify the setting condition.
4
When specifying the number of speakers installed.
• Each time this button is pressed, the speaker layout
changes as follows:
When specifying the subwoofer or the crossover frequency.
• Each time the ADJUST UP( ) or CURSOR RIGHT( )
button is pressed, the subwoofer changes as follows:
S No display
(Subwoofer: Yes) (None)
• Each time the ADJUST DOWN( ) or CURSOR
LEFT( ) button is pressed, the crossover
frequency(“CUT”) changes within the range of 40~130
Hz in 10 Hz intervals.
• In case that the subwoofer setting is
“S”(Subwoofer:Yes), if it is possible to adjust the
volume and crossover frequency on your subwoofer,
set the volume to about medium level (or slightly less),
and set the crossover frequency to the maximum.
Start the auto speaker setup procedure.
5
Notes:
• Because the test tones are very loud, ensure
there are no infants or small children in the
room.
• For best results, ensure the room is as quiet as
possible during the auto speaker setup
procedure.
If there is too much ambient noise, the results
may not be satisfactory.
• Loud test tones are output from each speaker.
• To stop the auto speaker setup procedure, press the
(MEMORY/) ENTER button.
To retry the procedure, press the (MEMORY/)
ENTER button again.
•After the auto speaker setup procedure has been
completed, “SET MEMO” will be displayed.
• If “>ERROR<” is displayed, there may be a problem
with the speaker or microphone connection.
While displaying “>ERROR<”, to retry the procedure,
press the ADJUST UP( ) or CURSOR RIGHT( )
button and to exit from the procedure, press the
ADJUST DOWN( ) or CURSOR LEFT( ) button.
• If retrying the procedure does not fix the problem, turn
off the power and check the speaker or microphone
connections.