Filter
Top Products
62
INSTALLER
INSTALLATION MENU
disabled zone. If enabled, an All On command activated from
another zone will turn on the enabled zone.
3. PARTY ENABLE - This feature is either disabled or enabled. If disabled, Party Mode
(PtyEn) activation from another zone will not affect the disabled zone. If
enabled (default), the zone will participate with Party Mode.
4. MASTER ENABLE - This feature is either disabled or enabled. If disabled, the zone
(MstEn) cannot host a master keypad during Party Mode. If enabled
(default), the zone has the option of hosting the Master keypad.
5. MUTE ENABLE - This feature is either disabled or enabled. It allows the option of
(MutEn) enabling or disabling muting in a zone. If disabled, the zone will
not mute. If enabled (default), the zone will be muted when a
mute signal is received.
CTRLR SETUP (CtlId)
Controller Setup is the basic configuration of the controller. This setup menu selects the options for
Controller ID and Factory Initialization.
See Controller Setup - Flow Chart page 75
1. CONTROLLER ID - This defines the Controller ID for this system. The default is 1 but
(CtlId) when multiple controllers are used, each additional controller ID
must be sequential and unique and be set before being connect-
ed to the system. Note that the system must be restarted before
the controller will assume the new ID.
2. FACTORY INIT -
WARNING: This procedure returns the controller to its
(FInit)
original settings - use with discretion.
Factory Initialization allows the installer to erase all programmed
settings and returns the settings to the factory default settings.
All settings including source equipment IR commands will need to
be reentered. An “Are you sure?” prompt and a “no” response
allows the installer to cancel the reset; a “yes” at the prompt will
load factory/default settings.
POWER MANAGEMENT (PwMgt)
The CAM6.6 is capable of managing the power state of the connected source equipment. The power
management is configured on a source-by-source basis.