Filter
Top Products
57
KEY CONFIG (KeyCf)
Key Configuration defines zone-specific key functions for each source.
See Key Config. - Flow Chart
page 70
1. ZONE NUM – Select the zone the key will be configured for. Changes are made
(Zone#) for that zone only; default setting is “All Zones.”
2. SOURCE NUM – Select the source the key will be configured for.
(Src #)
3. SELECT A KEY – Using or , select the keypad key to be configured.
(SelKy)
4. KEY TYPE – Either “Key Press,” “Key Hold” or “Both” will activate the command.
(KeyTp)
5. KEY NAME – Name that appears on the keypad display when the command is
(KeyNm) activated.
6. COMMAND TYPE – Select the type of source command (e.g., CD, TV, etc.).
(CmdTp)
a. Selected: Learned IR – Choose Learned IR if the pre-programmed IR code library does
(LrnIR) not support the source component.
i. LEARNED SRC – Select the learned source bank to be assigned to the source
(LnSrc) component. Procedure advances to KEY FUNCTION (step 8)
b. Selected: Unassigned The key configuration is cleared. Procedure advances to SAVE
(Unasg) CHANGES (step 9)
c. Selected: Default Default selects the same device type and device code previously
(Deflt) setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 8)
d. Selected: Macro: (To build macros, see Macro Editor page 65)
i. MACRO - Macro loads a series of commands which are processed when
(Macro) activated.
ii. MACRO ID – Enter the macro ID number. Menu advances to SAVE CHANGES
(MacID) (step 9)
e. All Other Selections: Procedure advances to DEVICE CODE (step 7)
7. DEVICE CODE – Enter source component code number listed in this manual’s
(DevCd) Reference section.
8. KEY FUNCTION – Select a function for the button.
(KeyFn)
INSTALLER
INSTALLATION MENU