Filter
Top Products
Installation
LightStyle™ LS-12HBd Installation/Operation Manual 51
PRE
L
IMINAR
Y
3.9
Primary Lens
Adjustments: Focus,
Zoom and Position
Lens zoom, focus and position are motorized adjustments that are adjustable using the
remote control (Figure 2-7). This allows you to adjust the focus and image size while at the
screen for more accurate results.
To access the motorized lens controls:
1. On the Dimension Digital Controller remote control or front panel, press MENU.
2. Select Service from the Main Menu and enter the Service Menu passcode.
3. Select Display Device from the Service Menu.
4. Select Configure from the Display Device menu, then select Lens.
The Lens menu controls operate as described below.
FocusTo focus the projected image, use the cursor buttons to highlight “In” or “Out.” Then,
press and hold the ENTER button.
ZoomTo make the picture smaller (zoom out), use the cursor buttons to highlight the minus sign
(-). Then, press and hold the ENTER button.
To enlarge the picture (zoom in), use the cursor buttons to highlight the plus sign (+).
Then, press and hold the ENTER button.
Vertical and Horizontal
Lens Shift
To change the lens position, use the cursor buttons to highlight “Left,” “Right,” “Up” or
“Down” in the Lens menu. Then, press and hold the ENTER button to shift the lens in that
direction.
To return the lens to its home position (no horizontal or vertical shift), use the cursor
buttons to highlight “Home” in the Lens menu. Then, press the ENTER button.
3.10
Adjusting the Picture
Orientation
By default, the LS-12HBd is configured for a “floor/front” installation, in which the
projector is installed upright and in front of the screen. If it is installed behind the screen
and/or mounted on a ceiling, you must change the picture orientation. To do this:
1. On the Dimension Digital Controller remote control or front panel, press MENU.
2. Select Service from the Main Menu and enter the Service Menu passcode.
3. Select Display Device from the Service Menu.
4. Select Configure from the Display Device menu, then select Installation.
5. Select Orientation, then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match
the installation method.
If you prefer, you can also perform lens adjustments from the
projector using the built-in keypad. For detailed instructions, refer to
KEYPAD on page 7.
You must enter a passcode to access the Service menu.
Note
Note
You must enter a passcode to access the Service menu.
Note