Filter
Top Products
Specifications
LightStyle™ LS-12HBd Installation/Operation Manual 125
PRE
L
IMINAR
Y
7.1
LS-12HBd Projector
Specifications
Table 7-1 lists the LS-12HBd projector specifications.
7. Specifications
Table 7-1. LS-12HBd Projector Specifications
Projector Type: Digital Light Processing™ (DLP), 3-chip, 16:9 SuperOnyx™
DMD™
Native Resolution: Full HD 1920 x 1080 (1080p)
Estimated Lamp Life: 2000 hours, typical (260W power setting)
3000 hours, typical (230W power setting)
Aspect Ratios: 4:3, Letterbox, 16:9, VirtualWide, Cinema, Virtual Cinema,
Native
DTV Compatibility: Refer to Table 7-2
Picture Size (16:9 Screen): Recommended Width: 80 - 117 in.
Maximum Width: 175 in.
Processing: Runco Dimension Digital Controller with ViVix IV™ technology
and BRiC (Backup, Recovery and Clone) tool
Control Options: • Serial commands via RS-232
• Discrete infrared (IR) remote
• Consumer Electronics Control (CEC) protocol support via
HDMI
•Ethernet
Inputs and Outputs: • Digital Video x 2 (from Dimension Digital Controller)
• RS-232 (female DB9) for serial communications
• 3D Sync Out (female 3-pin, VESA standard mini-DIN) to IR
Emitter
Video Standards: NTSC, PAL, SECAM, CEA-861D
Calibration: ISF Certified Calibration Configuration
Throw Distance
(Factor x Screen Width):
Refer to Table 3-3
Horizontal & Vertical Offset: Proteus 1: None
Proteus 2, 3, 4, 5, 6:
Horizontal: 30% of screen width left or right
Vertical: 65% of screen height up or down
Light Output (2D): CSMS Specifications* – Home Theater Calibration:
2,592 ANSI Lumens; 94 Foot-Lamberts (fL)
Uncalibrated: 3,780 ANSI Lumens
*Measured on a 1.0 gain, 84" wide 16:9 screen
Contrast Ratio: CSMS Contrast Ratio: >250:1 (ANSI);
10,000:1 full-on, full-off
Illumination System: 230W HPM lamp