Filter
Top Products
Operation
LightStyle™ LS-12HBd Installation/Operation Manual 93
PRE
L
IMINAR
Y
• Logo LED: Select Logo LED from the Front Panel Brightness menu to adjust the
brightness of the large, illuminated logo on the left side of the display. The range is from
0 (off) to 31.
• Standby LED: Select Standby LED from the Front Panel Brightness menu to change
the behavior of the front-panel STANDBY indicator LED. When set to ON, the LED
lights amber when the system is in standby mode; otherwise, it is off. When set to OFF,
the LED is always off.
• LCD: Select LCD from the Front Panel Brightness menu to adjust the brightness of the
front-panel LCD. The range is from 0 (off) to 4.
Auto Power Off: Select Auto Power Off from the Service menu to have the LS-12HBd
turn itself off after a specified period of time.
•Enable: By default, Auto Power Off is set to No Signal. With this setting, the
LS-12HBd powers off after a specified period of inactivity (no source signal present). To
change this behavior, select Enable from the Auto Power Off sub-menu. Then, set it to
On to have the LS-12HBd power off after the specified time period whether a source
signal is present or not. Or, set it to Off to disable this feature altogether.
•Hours: Select Hours from the Auto Power Off sub-menu to specify the number of
hours after which the LS-12HBd should power off. The default time-out period is one
hour; the range is from 1 to 24 hours.
Standby Mode: Select Standby Mode from the Service menu to control the Dimension
Digital Controller’s power management feature.
•Choose Low Power (the default setting) to have the Dimension Digital Controller shut
down completely when it is turned off. This conserves power but increases the amount
of time required by the Dimension Digital Controller to start up when it is turned on.
• Fast Startup is a “quick-start” mode that keeps the Dimension Digital Controller
running when it is turned off, even though it appears to be in standby mode. This
results in much quicker startup times but consumes more power.
System Reset: To reset ALL controller settings (including image settings) back to their
factory defaults, choose System Reset from the Service menu.
A confirmation message appears. Select Yes to continue with the reset or select No to
cancel.
During a firmware upgrade, this LED lights at full brightness
regardless of the Logo LED setting.
During a firmware upgrade, this LED lights at full brightness
regardless of the Standby LED setting.
This action is not undoable. Proceed with caution! Before you
perform a System Reset, save your “Custom” Memory Presets
(page 70) and ISF Day/Night Memory Presets (page 78).
Note
Note
Caution