Filter
Top Products
Installation
28 LightStyle™ LS-12HBd Installation/Operation Manual
PRE
L
IMINAR
Y
3.4
Installing the Optional
Anamorphic Lens
Mount
If you are installing a standard LS-12HBd (without an anamorphic lens), skip this step and
proceed with Mounting the LS-12HBd (page 33).
If you are installing an LS-12HBd with an anamorphic lens, proceed as follows to install
the lens mount and transport assembly.
Package Contents The LS-12HBd Anamorphic lens mount kit consists of the following items. Some
components shipped with your projector may differ slightly from what is shown in these
instructions. If any items are missing or damaged, please contact your Runco dealer or
Runco Customer Service at (800) 23RUNCO.
• Transport Assembly Attachment Plate
• Attachment plate hardware (screws,
washers and spacers)
• Attachment plate security hooks and
related hardware (chain, chain ends,
nuts and washers)
• Transport Assembly
• Transport mounting hardware
• Lens bracket mounting hardware
• Power supply
• Remote control unit and batteries
• Anamorphic lens and mounting bracket
1. Do not install the anamorphic lens yet, only the lens mount and
transport assembly. You will install the anamorphic lens after you
install the projector and adjust the primary lens.
2. Some components shipped with your projector may differ slightly
from what is shown in these instructions.
Note
➤