Filter
Top Products
Installation
20 LightStyle™ LS-12HBd Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the LS-12HBd installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer
to page...
1
Choose a location for the projector 21
2
Install anamorphic lens mounting assembly (optional) 28, 40
3
Mount the projector 33
4
Mount the Dimension Digital Controller 35
5
Connect the Dimension Digital Controller to the projector 36
6
Connect other external equipment to Dimension Digital Controller
(optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (retractable screens or
screen masking)
• External IR repeater
• Network hub, router or gateway (Ethernet)
38
7
Connect signal sources to the Dimension Digital Controller 43
8
Connect the Active 3D Emitter to the Dimension Digital Controller 49
9
Connect system components to AC power 49
10
Apply power to the projector 50
11
Adjust primary lens: projected image size (zoom), position (shift)
and focus
24, 51
12
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation
51
13
Use Image Alignment controls to fine-tune image geometry 52
14
Install and adjust secondary anamorphic lens (optional) 54
15
Display calibration: adjust the following for each Dimension
Digital Controller input and display mode (resolution/frame
rate); save settings when finished:
• Aspect ratio • Color level
• Brightness • Tint
• Contrast • Input position
• Color temperature and white balance
60 through 79
16
Prepare Runco Active 3D Glasses for use and test with 3D source
material
94