Filter
Top Products
Section 2: Installation & Programming
21822666 2-61
Table 2-5A. Menu & Command Descriptions
Continued
Code Description
89 ON/OFF Cycles - Displays and changes the number of ON/OFF cycles.
9 DEVICE SETUP - The DEVICE SETUP menu activates and defines the AMPLIFIER, VOLUME
CONTROL, and IR REMOTE options.
90 AMPLIFIER - The AMPLIFIER menu activates and defines the AMPLIFIER options. (4-channel
preamplifier only)
91 IR REMOTE - The IR REMOTE menu activates and defines IR REMOTE options.
92 Main Display Line - Sets which display line is used for the scrolling line, and which is used for the main
display. Hold RESET and push 9 to select, and then push POPULAR.
93 BGM Delay Time - Time in seconds to delay BGM mode after the phono goes into standby mode. The
range is 1 to 99 seconds. This is a minimum time as it does not include the time to put the disc away if BGM
delay time is set longer than 2 seconds. Type the number of seconds and push POPULAR.
94 Lead Singer - Sets the Karaoke Lead Singer on LEFT or RIGHT channel. Hold RESET and push 9
to select, and then push POPULAR. (4-channel preamplifier only)
95 Amp Factory Load - Loads factory settings for the AMP. (4-channel preamplifier only)
96 Autoplay/BGM Volume - Displays and sets autoplay volume to OFF, SEPART, or LOCKED. Hold
RESET and press 9 to toggle between OFF, SEPARATE, AND LOCKED. Push POPULAR to save
your choice. OFF means there is 1 adjustable volume for BGM, Autoplay, and paid play (if playing ENH
autoplay sel with REL VOL set, only the volume for that selection will be different by the REL VOL amount).
SEPARATE means there is one adjustable volume for BGM and Autoplay (if playing ENH autoplay sel
with REL VOL set, only the volume for that selection will be different by the REL VOL amount), and another
for paid play. LOCKED means there is one locked volume for BGM and autoplay (if playing ENH autoplay
sel with REL VOL set, only the volume for that selection will be different by the REL VOL amount), and
another adjustable volume for paid play. To set the locked level, make a selection, wait until it starts playing.
Use IR remote to set the volume you like for autoplay. Then go to the SERVICE mode. Type 96. Hold
RESET and toggle 9 until display shows AP VOLUME LOCKED, then press POPULAR.
(4-channel preamplifier only)
97 Volume Option - This sets the way the volume control up/down buttons affect the volumes of the 4
different AMP volume channels (for master volume control - not for MIC volume control).
1 means any of CH1 or CH2 volume up/down switches will adjust AMP CH1 and CH2 volumes (those
2 AMP volumes are locked together). Any of CH3 or CH4 switches will adjust AMP CH3 and CH4
volumes (those 2 AMP volumes are locked together).
2 means CH4 volume up/down switch controls AMP CH4 volume. Any of CH1, CH2, or CH3 switches
will adjust AMP CH1, CH2, and CH3 volumes (those 3-amp volumes are locked together).