Filter
Top Products
15RF-WHD200
6 To turn the WirelessHD kit off, perform one of the following steps:
• Power off your TV or projector and source devices - when the
WirelessHD transmitter and receiver have not detected a signal, they
will automatically go into sleep mode.
Note: When the WirelessHD transmitter and receiver go into sleep mode, the power
and link status LEDs on both units will blink slowly.
Also note: Some HDMI source devices like TiVo set-top-boxes have no easy way to shut
them off. The automatic HDMI port selection feature in the WirelessHD transmitter
will therefore always select such an always-on source and will always keep the
WirelessHD transmitter connected to the receiver. In this case please use steps below.
• Manually place the WirelessHD transmitter into sleep mode by
pressing the SLEEP button on the included remote control (be sure
to point the remote toward the WirelessHD transmitter).
• Turn the power switch on the WirelessHD transmitter and receiver
to the OFF position.
7 To return the WirelessHD transmitter and receiver from sleep mode to
on, perform the following steps:
a) Power on the TV or projector, and switch it to the HDMI input with
which the WirelessHD receiver is connected.
b) Power on the source device you wish to view that is connected to the
WirelessHD transmitter.
Note: Depending on the brands/models of devices you have connected, the
WirelessHD transmitter and receiver may automatically return from sleep mode and
re-establish their link. If this does not happen with your devices, use the SLEEP button
on the included remote control to manually return the WirelessHD transmitter and
receiver from sleep mode.
HDMI-CEC (Consumer Electronics Control) support
For best operation, connect sources which are HDMI-CEC capable
(DVD, Blu-ray player, and so on) to your WirelessHD transmitter. If
your TV is also HDMI-CEC (v1.3a or newer) capable, your TV's OSD
(on-screen display) should let you select any of the HDMI-CEC source
devices connected to the WirelessHD transmitter adapters on the
WVAN.
Turning off an HDMI-CEC enabled TV sends a broadcast message to
all wired HDMI and WirelessHD source devices, giving them the
opportunity to power off automatically (if they support HDMI-CEC
and this option is enabled in the device's settings).
RF-WHD200_10-1353_MAN_ENG_V3.fm Page 15 Monday, March 14, 2011 3:45 PM