Filter
Top Products
14
3 Power on the source component you wish to view.
4 Power on the WirelessHD transmitter.
5 Switching the WirelessHD transmitter to the correct HDMI input:
Note: When switching between the four HDMI ports, it is normal for the switching to
take an average of about 10 seconds (sometimes up to 20 seconds; the further the
WirelessHD transmitter and receiver are from each other, the longer the switching
will take). The WirelessHD receiver will output a black video screen at 480p (720 x
480) resolution @ 60Hz with no audio during the switching process.
• The WirelessHD transmitter may automatically switch to the HDMI
port of the source device that is most recently powered on
(depending on the type of source component that is connected). If it
does not automatically switch to the correct HDMI port, or you want
to switch to a different HDMI port for another source device, follow
one of the following steps:
• Press the corresponding button on the included remote control
(HDMI 1-4) to switch the WirelessHD transmitter to the HDMI port
for the source device you wish to view (be sure to point the remote
at the WirelessHD transmitter).
• If you have misplaced the remote control, or do not wish to use it,
you can also quickly press the HDMI SW button on the back of the
WirelessHD transmitter to sequentially toggle through the four
HDMI ports.
Note: Be sure to quickly press the HDMI SW button for less than one second to
switch HDMI ports. If you hold this button down for three seconds or more, the
transmitter will search for a different receiver and you may lose the connection
between the transmitter and receiver. If this happens, press and hold the HDMI
SW button again for at least three seconds to re-establish the link between the
WirelessHD transmitter and receiver.
• If your TV or projector and source devices support CEC (consumer
electronics control), you will see the available connected devices
on the Input screen of the TV or projector. Simply select the device
you wish to view by selecting it from this on-screen list. Refer to the
documentation that came with your devices to verify if CEC is
supported; often marketed under different trade names, including:
Anynet+ (Samsung); Aquos Link (Sharp); BRAVIA Sync (Sony);
HDMI-CEC (Hitachi); Kuro Link (Pioneer); CE-Link and Regza Link
(Toshiba); RIHD (Remote Interactive over HDMI - Onkyo); SimpLink
(LG); HDAVI Control, EZ-Sync, VIERA Link (Panasonic); EasyLink
(Philips); NetCommand for HDMI (Mitsubishi); INlink (Insignia).
RF-WHD200_10-1353_MAN_ENG_V3.fm Page 14 Monday, March 14, 2011 3:45 PM