Filter
Top Products
12
6 Power on the WirelessHD transmitter and receiver. The HDMI input port
LED on the transmitter should light continously (stop blinking) to
indicate that the desired input is selected with active video. If this
selection does not occur automatically, please use the included remote
control or HDMI Select Switch on back of the transmitter to select the
desired input port. See step 5 in “Using the WirelessHD Kit” section on
page 13.
Note: The transmitter and receiver are pre-paired and should discover each other
shortly after being powered on. However, should you experience an excessively long
delay (over five minutes) for the link to be established, press the HDMI/WVAN switch
on the back of the transmitter for at least three seconds to establish the link (the
receiver must also be powered on during this process).
Mounting the receiver on a wall
For best performance, mount the receiver on the wall next to the TV
(or on the ceiling next to a projector), with a clear view of the room. It
should NOT be mounted behind the TV or projector. Try positioning
the receiver above, below, or next to the TV or projector and check
for best signal quality before securing the mounting bracket to the
wall or ceiling.
If mounting the receiver on the wall or ceiling is not an option for
your installation, the receiver can be placed on a flat surface, but the
operating range may be reduced.
To mount the receiver on a wall:
1 Place the included receiver mounting bracket on the wall or ceiling in
the desired location and mark the holes with a pencil.
Note: The mounting location should be within the length of the included power cord
to an available AC outlet.
RF-WHD200_10-1353_MAN_ENG_V3.fm Page 12 Monday, March 14, 2011 3:45 PM