RCA HT35752BD Home Theater System User Manual


 
6
Install TV Cabinet
The TV cabinet is shipped assembled. Before final positioning of the TV cabinet in
the opening, be sure to run the TV’s power cord and the connectors from the jack
panel extension cable up through the square opening in the right rear of the
cabinet. Be sure that the wires for the front and center speakers are accessible.
Mount the TV Cabinet
1. Place the TV’s power cord and connectors from the jack panel so that you
will be able to easily feed them through the back of the TV cabinet as it is
being installed.
2.Place TV cabinet on top of component and software cabinet. Move the TV
cabinet back until the wood strip at the bottom front of the TV cabinet fits
snugly into the two L-notches on top of the component and software
cabinet.
3.Secure the TV cabinet to the component and software cabinet using
four #8 x 2-1/4” screws — two at the front and two at the rear as shown
below.
4.Use the leveling legs in the bottom of the component and software cabinet
to level the system, if necessary.
Wood Strip
Screw HolesScrew Holes
L-Notch L-Notch
Leveling Legs
Screw Holes
TV Cabinet
Component and Software Cabinet