RCA HT35752BD Home Theater System User Manual


 
2
Introduction
Get Ready
Unpack System
Important Note: Be sure to record all of the Model and Serial Numbers on the
“Limited Warranty Registration” form located in the accessory kit for the owners to
submit with their registration cards.
1.Look inside the accessory kit (ACCKIT752) for the “Installation Checkoff List.”
This list is provided for each system and must be filled out for each installation.
2.Unpack all of the boxes.
3.Look inside the accessory kit (ACCKIT752) for the “Inventory Checklist.” If you
are missing any items, contact 1-800-721-4007.
Check the Installation Area
After unpacking the system, check the installation area to make sure the following
things are ready.
1.A 20 AMP dedicated duplex power source located on the rear wall directly behind
the speaker opening.
2.For emergency situations, a system power disconnect switch should be connected
to the dedicated duplex as shown on the blueprint.
3.16-gauge or larger speaker wire run from audio/video component and software
cabinet area to each rear wall or ceiling speaker opening.
4.Cable TV and/or home antenna source(s) available.
5.Make sure the support frame for the audio/video component and software
cabinet is level.
This guide contains instructions for installing and connecting components of the
35-inch built-in Custom Home Theatre system. These step-by-step procedures
are presented in sequence and should be followed carefully. Use the small boxes
next to the instructions to check off completed tasks.
Caution: The speaker wire in the walls must be
both UL listed and CL2 type. Wiring must also
meet all state and local code requirements.
We recommend that two people are available to install this system.