RCA HT35752BD Home Theater System User Manual


 
19
Connect TV
The television is the last component of the system to be installed.
These connections can be made while the TV is still outside of the TV
opening area. Do not move the TV into place until the system has
been completely tested for operation.
1.Connect the audio/video component rack’s jack panel extension
cable connectors to the corresponding terminals on the jack panel
on the back of the TV. All plugs, connectors, and jacks are labeled.
2.Attach the TV’s power cord plugged into the wall earlier to the
power connector on the back of the TV.
A/V Receiver
TV
Fan
LaserDisc Player
CD Player
VCR
Wall Outlet
Outlet Strip
Check Power Cord Connections
1.Make sure all components are plugged in correctly.
• The TV and outlet strip should be plugged into the switched 20
amp duplex (electrical outlet).
Important Note: The builder should have added a system disconnect
switch to the system so the owner can manually shut off power to all
components. Therefore it is very important that the TV and outlet strip
be plugged into the switched 20 AMP duplex.
• The audio/video receiver, VCR, and LaserDisc player should be
plugged into the outlet strip
• The CD player and cooling fan should be plugged into one of the
switched outlets on the back of the audio/video receiver.
Connect Components
(continued)