Filter
Top Products
3
Before Use
Read this before operation
• As the unit may become warm during operation, always
leave sufficient space around the unit for ventilation.
The ventilation holes should not be covered. Make sure
there is at least 50 cm of space above and at least 10 cm of
space on each side of the unit. Do NOT place anything on
top of the unit.
• The voltage supplied to the unit should match the voltage
as printed on the rear panel. If you are in any doubt
regarding this matter, consult an electrician.
• Choose the installation location of your unit carefully. Avoid
placing it in direct sunlight or close to a source of heat. Also
avoid locations subject to vibrations and excessive dust,
heat, cold or moisture.
• Do not place the unit on the amplifier/receiver.
• Do not open the cabinet as this might result in damage to
the circuitry or electrical shock. If a foreign object should get
into the unit, contact your dealer or service company.
• When removing the power plug from the wall outlet, always
pull directly on the plug, never yank the cord.
• Do not attempt to clean the unit with chemical solvents as
this might damage the finish. Use a clean, dry or slightly
damp cloth.
• Keep this manual in a safe place for future reference.
How to Reset the Settings to the FACTORY DEFAULTS
Memory Backup
If the power supply is interrupted for 14 days or longer, the
settings kept in memory (such as preset stations and
speaker settings) will be erased.
Restoring factory settings
If you have made a lot of changes to the setup, and want to
restart from a known set of options, restore the unit to the
factory settings as follows:
1. With the unit in the standby mode, briefly press the
STANDBY/ON switch while holding down the
MEMORY/ENTER button.
• Release the MEMORY/ENTER button immediately after
pressing the STANDBY/ON switch.
The model name, etc. appears on the display.
2. Press the MEMORY/ENTER button.
The unit turns standby.
3. Press the POWER switch to turn the unit off.
All memories are erased, and the unit returns to the factory
settings.