Filter
Top Products
19
Speaker Configuration 4
Balancing relative volume between speakers during
playback of DVD
(During playback of DVD,) press the CH.SEL (CHANNEL
SELECTOR) button.
Each time the CH.SEL button is pressed, the channel is
changed as follows:
REF.1 or REF.2: stored setting
USER: “USER” appears only when the current setting is
different from REF.1 or REF.2.
If the balance has already been set using the test
tone function, you don’t have to change the setting of
speakers.
If you want to change the LFE level for Dolby Digital or
DTS, press the CH.SEL button repeatedly until “DD L
(Dolby Digital LFE)” or “DTS L (DTS LFE)” appears on the
display.
(LFE: Low Frequency Effect)
•A speaker set to “None” or “No” will not appear on the
display.
• When STEREO or Virtual Surround is selected, or when the
SPEAKER button is set to off, only the front speakers will
appear on the display.
Within 5 seconds, press the LEVEL buttons to change the
level.
• The level of speakers can be adjusted in 1 dB steps from
–15 dB to +15 dB.
• The LFE level can be adjusted in 1 dB steps from –10 dB to
0 dB. The default setting is 0 dB. Lower the LFE level if
necessary.
Repeat step and to change other settings.
When all the configurations have been finished, leave the
unit idle for 5 seconds to exit the Channel Select mode.
21
2
1
How to store your channel level setting
1. When all the settings have been finished in step 2, press
the MEMORY/ENTER button of the main unit.
“1” blinks on the display.
2. Within 5 seconds, press the LEVEL button to select “REF.1”
or “REF.2”.
3. Within 3 seconds, press the MEMORY/ENTER button to
save and exit.
How to call the stored setting
1. Press the CH.SEL button to display USER, REF.1 or REF2.
2. Press the LEVEL button to select “REF.1” or “REF.2”.
2
1