Filter
Top Products
User’s Manual of FGSW-2620VM / FGSW-2620PVM
21
LNK/ACT 100 Green
Lit: indicate that the port is operating at 100Mbps.
Off: indicate that the port is operating at 10Mbps or 1000Mbps.
Blink: indicate that the Switch is actively sending or receiving data over that port.
FGSW-2620PVM LED indication
Figure 2-4: FGSW-2620PVM LED panel
System
LED Color Function
PWR Green Lights to indicate that the Switch has power.
Per 10/100Base-TX, PoE interfaces (Port-1 to Por-24)
LED Color Function
Lights:
To indicate the link through that port is successfully established.
LNK/ACT
Green
Blink:
To indicate that the Switch is actively sending or receiving data over that port.
Lights:
To indicate the port is providing 48VDC in-line power.
PoE In-Use
Orange
Off:
To indicate the connected device is not a PoE Powered Device (PD).
Per 10/100/1000Base-T port /SFP interfaces
LED Color Function
LNK/ACT 1000 Green
Lit: indicate that the port is operating at 1000Mbps.
Off: indicate that the port is operating at 10Mbps or 100Mbps.
Blink: indicate that the Switch is actively sending or receiving data over that port.
LNK/ACT 100 Green
Lit: indicate that the port is operating at 100Mbps.
Off: indicate that the port is operating at 10Mbps or 1000Mbps.
Blink: indicate that the Switch is actively sending or receiving data over that port.
1. Press the RESET button once. The t Switch will reboot automatically.
2. Press the RESET button for about 10 seconds. The Switch will back to the factory default mode; the
entire configuration will be erased.
3. The 2 Gigabit TP/SFP combo ports are shared with port 25/26 of FGSW-2620VM / FGSW-2620PVM.
Either of them can operate at the same time.