Filter
Top Products
7
PREPARATION
Before You Start
Operating range of remote
control unit
The area in which you can use the remote control to
operate the VSX-D938TX/D908TX/D908TX-G is fairly
large. To use, point the remote control toward the
remote sensor on the front panel of this unit while
within the range shown below.
Remote control may not function properly if:
• There are obstacles between the remote
control and the remote sensor.
• Direct sunlight or fluorescent light is
shining onto the remote sensor.
• The receiver located near a device
emitting infrared rays.
• Operated simultaneously with another
remote control which uses infrared rays.
7 m
12
3
CAUTION!
Incorrect use of batteries may result in such hazards as leakage and bursting. Observe the following
precautions.
• Never use new and old batteries together.
• Insert the plus and minus sides of the batteries properly according to the marks in the battery case.
• Batteries with the same shape may have different voltages. Do not use different batteries together.
30°
30°
Preparing the Remote Control
Loading the batteries
Load the batteries into the remote control as shown below. Please use alkaline batteries.
When you notice a decrease in the operating range of the remote control, replace all batteries with new ones.
AA drycell batteries
(("AA" IEC LR6) × 2)
Operating other PIONEER
components
Connecting an optional control cord allows you to
operate other PIONEER components simply by
pointing the receiver’s remote control at the remote
sensor on the front panel of the receiver. The
receiver then sends the remote control signals to the
other devices via the CONTROL OUT terminal.
• You can also control PIONEER
components (and those made by other
manufactures) by pointing the receiver’s
remote control directly at the respective
component. This type of operation does
not require control cords. All you have to
do is recall the appropriate preset code
(see P.79 (VSX-D938TX), P.83 (VSX-
D908TX/D908TX-G)).
• If you use a remote control hooked up via
the CONTROL IN jack with a control cord,
you will not be able to use this unit’s
remote control.
OUT
IN
CONTROL
OUT
IN
CONTROL
PIONEER component
bearing the Î mark.
Remote Control
To CONTROL IN
terminal of another
PIONEER component
bearing the Î mark.
Receiver