56
Remote Control of Other Components
Learning mode: Programming signals from other remote controls
If preset codes are not available for your component(s), or the available preset codes do not operate correctly,
you can use this function to program in signals from the remote control(s) of your other component(s). This
operation can also be used after recalling a preset code to program additional operations not covered in the
preset codes.
1
Turn on your TV and the receiver.
Make sure your TV is set to the appropriate video input (e.g. VIDEO
1).
2
Press REMOTE SETUP.
The REMOTE SETUP menu appears on your TV screen.
Select Remote
Setup Mode
Remote SETUP+1
Preset Recall
Remote SETUP+2
Learning
Remote SETUP+3
Multi-Operation
Remote SETUP+4
Direct Function
3
Press REMOTE SETUP and
2
at the same time to
select the LEARNING SETUP mode.
All the MULTI CONTROL buttons (except the TUNER button) start
to blink.
To cancel LEARNING SETUP mode
Press REMOTE SETUP.
Learning Setup
1Place both commanders
pointing at each other.
2Select the item from
the Multi-control
buttons that should be
duplicated. (ex. DVD)
Multi-control button
starts blinking.
EXIT=Remote setup
4
Press MULTI CONTROL for the component you want
to control.
Each button can be set to control one of the following
components.
The selected button continues to blink.
Learning Setup
3Press one button that
should be duplicated.
4Multi-Contorol button
lights up.
5Press one button on the
original commander, and
hold 2 to 10 seconds.
6Repeat this process to
duplicate next command.
EXIT=Remote setup
S0URCE
DVD/LD TV/SAT
VCR1 VCR2
CD
TV VOL
TV FUNC
MENU
ENTER
STEREO
DIGITAL NR
MIDNIGHT
ADVANCED STANDARD
DSP
THX
MUTE
TV
VOLUME
MD/
TAPE1
TUNER
TV CONT
RECEIVER
MULTI
OPERATION
CLASS MPX
MULTI CONTROL
DIRECT ACCESS
STATION
CHANNEL
TUNING
DISPLAYRF ATT
TV CONTROL
FUNCTION
SIGNAL
SELECT
EFFECT
/CH SEL
2/dts
AV PREPROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
REMOTE
SETUP
SYSTEM
SETUP
BAND
SYSTEM
OFF
1
23
4
56
7
+10
89
0
DISC
Î
¶
738
1¡4¢
+
-
+
-
+
-
MPEG
3
2,3
4
1
VSX-D938TX