Pioneer VSX-D938TX Stereo Receiver User Manual


 
15
Connecting Your Equipment
PREPARATION
First turn the receiver off, then press the power button
while holding down the SPEAKERS button.
Choose the impedance setting by pressing the SPEAKERS button again.
You can choose the 8 -16 setting or the 6 -8 setting.
To check which impedance the amplifier is set to hold down
the SPEAKERS button for 2-3 seconds. You willl get a display
like the one shown below right telling you the speaker
impedance setting.
7 Speaker terminals
1 Twist exposed wire
strands together.
2 Loosen speaker
terminal and insert
exposed wire.
3 Tighten terminal.
10 mm
Speaker impedance
You can change the speaker impedance to suit the kind of speakers you have in your home system but we
recommend using speakers with an impedance of 8 -16 (the default setting). If you are using 6 -less than
8 impedance speakers, you need to change the impedance setting.
(This display indicates an 6 -less than
8 impedance setting)
(This display indicates a 6 -less
than 8 impedance setting)
or
(This display indicates an 8 -16
impedance setting)
dB
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
dB
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
dB
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
STANDBY/ON
DSP
MODE
THX CINEMA ADVANCED STANDARD
STANDBY
AUDIO/VIDEO MULTI-CHANNEL RECEIVER
Digital
S
STEREO
/DTS
PHONES
S-VIDEO
5-CHANNEL EQUAL POWER OUTPUT
VIDEO
EXTERNAL
DECODER INDIRECTLOUDNESS MID
N
SPEAKERS
BASS +
L AUDIO R
VIDEO INPUT
MPEG
SPEAKERS
w STANDBY/ON
VSX-D938TX