Filter
Top Products
66
Recording from Audio Components
The following explanations show you how to record an analog audio signal with the component you connected
to the MD/TAPE 1 or TAPE 2 MONITOR jacks. Note that you cannot record an component that is only
connected digitally. If you want to record from a digital component, it must be connected in an analog manner as
well. If you want to record a digital signal, see the next page.
The receiver’s volume, channel level, tone (BASS, TREBLE, and LOUDNESS), and surround effects
have no effect on the recorded signal and the EXTERNAL DECODER input cannot be recorded.
1
Select the source component and put the receiver in
that function. Remember, SIGNAL SELECT must be
set to analog.
Press the SIGNAL SELECT button on the remote control (or use the
button on the front panel) and choose ANALOG. Recording
DIGITAL or AC-3 RF (VSX-D938TX only) signals is not possible.
2
Start recording with a TAPE or MD (etc.).
3
Playback the source to be recorded.
Record monitor (TAPE 2 MONITOR)
If you connect a cassette deck (etc.) with a record monitor function to
the TAPE 2 MONITOR jacks, you can listen to the sound of the
recording as it is recorded.
Press TAPE 2 MONITOR to switch between the sound of
the recording (TAPE 2 indicator on) and the sound of the
source component (TAPE 2 indicator off).
S0URCE
DVD/LD TV/SAT
VCR1 VCR2
CD
TV VOL
TV FUNC
MENU
ENTER
STEREO
DIGITAL NR
MIDNIGHT
ADVANCED STANDARD
DSP
THX
MUTE
TV
VOLUME
MD/
TAPE1
TUNER
TV CONT
RECEIVER
MULTI
OPERATION
CLASS MPX
MULTI CONTROL
DIRECT ACCESS
STATION
CHANNEL
TUNING
DISPLAYRF ATT
TV CONTROL
FUNCTION
SIGNAL
SELECT
EFFECT
/CH SEL
2/dts
AV PREPROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
REMOTE
SETUP
SYSTEM
SETUP
BAND
SYSTEM
OFF
1
23
4
56
7
+10
89
0
DISC
Î
¶
738
1¡4¢
+
-
+
-
+
-
MPEG
1
VSX-D938TX
Using Other Functions