Filter
Top Products
<ARB7050>
20
REMOTE CONTROL OPERATION
PUTTING BATTERIES INTO THE REMOTE
CONTROL UNIT
REMOTE CONTROL RANGE
1. Open the battery compartment cover on the rear of the
remote control unit. The cover should open easily if you slide
it in the direction of the arrow while pressing on it with your
thumb.
2. Press the RESET button in the center hole of the battery
compartment.
3. Take out the two supplied batteries size “AA” (IEC R6P), and
insert them into the battery compartment in accordance
with the indications in the compartment.
4. Close the cover of the battery compartment.
Incorrect use of batteries may lead to leakage or
rupture. Always be sure to follow these guidelines:
A:
Always insert batteries into the battery compartment correctly
matching the positive ª and negative · polarities, as indicated
inside the compartment.
B:
Never mix new and used batteries.
C:
Batteries of the same size may have different voltages, depending
on their type. Do not mix different types of batteries.
When operating the remote control unit, point the front of the
unit at the front panel of the receiver. The remote control unit
may be used within a range of about 7 meters (23 feet) from the
remote sensor, within angles of up to about 30 degrees.
Performance of the remote control unit is adversely affected in
the presence of a strong fluorescent light. Keep such lights
away, especially from the sensor window.
Battery Replacement
As battery power runs down, the range over which the remote
control unit can operate decreases. Also, ONE TOUCH
OPERATION and other buttons light less brightly.
When the range becomes too short, change the batteries.
–
+
–
+
30°
7m (23 feet)
30°