Filter
Top Products
<ARB7050>
14
90
3
60 30
0 (off)
2
33
FRONT PANEL FACILITIES
Auto stereo mode
Normally, leave in this mode for reception. When a stereo FM
broadcast is received, it will be automatically reproduced in
stereo.
Monaural mode
When receiving distant stations or stations with weak broadcast
signals, the input signal may be weak, thus resulting in increased
noise during FM stereo broadcasts. In this event, setting the
receiver to the monaural mode will reduce the noise. In this
case, however, FM stereo broadcasts will be reproduced in
monaural sound.
NOTE:
This button has no effect on reception of AM broadcasts.
MEMORY button:
Press this button to switch to the frequency preset mode.
SELECT button:
Press this button to switch to the station mode. Then you can
turn the multi-jog to select a station.
& DSP OFF button**
Switches DSP (( DSP MODE, * DOLBY PRO-LOGIC, 8 AC-3)
off.
* DOLBY* PRO-LOGIC button**
Switches DOLBY PRO-LOGIC SURROUND on and off.
( DSP MODE button**
Each time you press it, the mode and the display indications
change as follows:
) SUPER BASS button**
Press this button when you want to boost the bass.
_ BASS control
Use to adjust the low-frequency level. Turn clockwise to boost
bass, and counterclockwise to attenuate bass.
+ TREBLE control
Use to adjust the high-frequency level. Turn clockwise to boost
treble, and counterclockwise to attenuate treble.
¡ SUPER BASS control
Use to adjust the bass boost level when the SUPER BASS button
is set to on.
** Setting is memorized separately for each input selector
button.
*
Manufactured under license from Dolby Laboratories Licensing
Corporation. Additionally licensed under Canadian patent number
1,037,877. “Dolby”, “AC-3”, “Pro Logic” and the double-D symbol
are trademarks of Dolby Laboratories Licensing Corporation.
Fabriqué sous licence de Dolby Laboratories Licensing Corporation
et sous le brevet suivant: Canada 1,037,877. DOLBY, AC-3, PRO
LOGIC et le symbole double-D, sont des marques de Dolby
Laboratories Licensing Corporation.
9 MULTI-JOG
Use during tuner operation to select frequencies and station
numbers. During GUI operation, use to move the on-screen
cursor.
0 GUI ENTER button (GUI operation)
Press to execute an operation selected with the MULTI-JOG.
- INPUT ATT button
Press on, and audio input sensitivity is attenuated (–10 dB) to
prevent clipping due to excessively high input levels. Switch
this on if the overload indicator in the display section lights
during playback. When you switch it on, the ATT indicator
lights.
NOTE:
Operates only when a DSP mode other than AC-3 is on.
= GUI MODE button
Switches GUI MODE on and off.
~ MASTER VOLUME control
Use it to simultaneously adjust the sound volume from the
front, center, and rear speakers.
! SLEEP button/indicator
Activates the SLEEP timer. The length changes in the following
manner each time the button is pressed:
Unit: minutes
@ PHONES jack
Connect the plug on your headphones to this jack. Set SPEAKERS
A and B switches to off if you want to cut the sound from the
speakers and listen to it only through the headphones.
# VIDEO INPUT jacks
VIDEO components such as a VCR or TV camera, etc. can be
connected.
$ DIRECT button**/indicator
Press this to listen to source sound without passing the audio
signal through sound quality and balance adjusting circuitry.
DSP, super bass, INPUT ATT, rear and center speakers are
automatically switched off.
% Display section
See page 15.
^ TUNING MODE buttons
FM/AM button:
Use this to switch between FM and AM frequency band reception.
MPX MODE button:
Use to select the auto stereo mode or monaural mode when
listening to FM broadcasts. The monaural mode has been
selected when the MONO indicator in the display section is lit.
JAZZ
3
DANCE HALL
SIMULATED
SURROUND
22
33
THEATER
2
off