Filter
Top Products
Using other functions
09
77
En
Using the A/D converters to give
greater definition to 2-channel sound
This receiver has high-quality 192kHz (24bit) A/D
converters that can be used in parallel to provide greater
resolution of DSP processing with analog 2-channel
sources. There are two ways to get 192kHz A/D
conversion:
1 Switch the SD:1 NORMAL Stream Direct mode
on.
See Using the Stream Direct mode on page 45 for more on
this.
2 Select the STEREO listening mode and switch off
any other sound processing features.
These features include:
• Midnight/Loudness (page 50)
• Digital Noise Reduction (page 51)
• Dynamic Range Control (page 92)
Also, make sure you also switch the multichannel input
to 2 CHANNEL in Selecting USB and multichannel analog
input channels on page 47.
Dimming the display
You can choose between four brightness for the front
panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
• From the remote control receiver menu, press
DISPLAY DIMMER repeatedly to change the
brightness of the front panel display.
You may need to press on the Home menu ( )
first before reaching the receiver menu screen shown
below (use the / (cursor left/right) soft keys to go to
the previous/next menu screen).
Switching the speaker impedance
• Default setting: Speaker 6ΩΩ
ΩΩ
You can use speakers with a nominal impedance
between 4-16Ω but if you are using speakers with an
impedance of less than 6Ω, you must change the
impedance setting below.
• With the receiver in standby, press STANDBY/
ON while holding down the OPTION – button.
Each time you do this, you switch between the
impedance settings:
• Speaker 4ΩΩ
ΩΩ
– Use this setting if your speakers are
rated lower than 6Ω (down to 4Ω).
• Speaker 6ΩΩ
ΩΩ
– Use this setting if your speakers are
rated 6Ω–16Ω.
Note
• If you select Speaker 4ΩΩ
ΩΩ
above, the Stream Direct
setting is fixed at SD:1 NORMAL (see Using the
Stream Direct mode on page 45).
RECEIVER
RECEIVER
3/3
SB CH
MODE
INPUT
STATUS
INPUT
AT T
SPEAKER
A/B
VIDEO
SELECT
TAPE2
MONITOR
DISPLAY
DIMMER
RECEIVER
TV
CONT
STANDBY/ON
OFF ON
STANDBY
DVD/LD TV/DVD SAT VIDEO
VIDEO AUDIO
DVR/VCR1 VCR2 VCR3 CD TUNER P
CD-R/
TAPE1/MD
INPUT SELECTOR
PHONES
SP SYSTEM
A/B
SIGNAL
SELECT
VIDEO
SELECT
TAPE2
MONITOR
STREAM
DIRECT
SETUP
MIC
SB CH
MODE
DIGITAL IN
S-VIDEO VIDEO
VIDEO INPUT
AUDIOLR
MIDNIGHT
TONE
LOUDNESS OPTION DIGITAL NR INPUT ATT CLASS STATION
TUNER
ACOUSTIC
CAL.