Filter
Top Products
Before you start
01
11
En
2 Remove the battery cover.
3 Use a pen or other sharp instrument to press the
reset button located in the hole to the right (above
the battery).
After restarting the remote control, the touch screen
shows the Home menu.
Replacing the lithium-ion batteries
If you notice that the remote will no longer hold a charge,
you may need to replace the lithium-ion battery cells.
Caution
• The lithium-ion batteries may present a fire or
chemical burn hazard if misused. Do not
disassemble, heat above 100˚C (212˚F), or
incinerate.
• Replacement cells must be of type AZW7264,
manufactured by NEC TOKIN Corporation. Use of any
other battery cells may result in fire or explosion.
Contact the Pioneer Service Center specified on your
warranty card to obtain new batteries. Replacement
cells are not covered under warranty.
• Dispose of used battery cells immediately after
replacement. Keep away from children.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public institution’s rules that apply in your country or
area.
1 Use a small phillips screwdriver to remove the
screw fixing the battery cover to the back of the
remote.
2 Remove the battery cover.
3 Disconnect the old battery cell from the unit.
Do not pull the connector out by holding onto the
attached wires. Hold the connector firmly with your
fingers, or use a small screwdriver (or other sharp tool) to
disconnect it.
4 Connect the new battery cell.
Push the connector in until it is fully inserted. Make sure
you keep the wire out of the way and line up the cell
properly so that the battery cover can be closed easily.
RESET
RESET
RESET